Impact of Polypropylene, Steel, and PVA Fibre Reinforcement on Geopolymer Composite Creep and Shrinkage Deformations

Autor: Rihards Gailitis, Andina Sprince, Tomass Kozlovksis, Leonids Pakrastins, Viktorija Volkova
Rok vydání: 2023
Předmět:
Zdroj: Journal of Physics: Conference Series. 2423:012030
ISSN: 1742-6596
1742-6588
DOI: 10.1088/1742-6596/2423/1/012030
Popis: For the last 40 years, there has been increased interest in geopolymer composite development and its mechanical properties. In the last decades, there have been cases when geopolymer composites have been used for civil engineering purposes, such as buildings and infrastructure projects. The main benefit of geopolymer binder usage is that it has a smaller impact on the environment than the Portland cement binder. Emissions caused by geopolymer manufacturing are at least two times less than emissions caused by Portland cement manufacturing. As geopolymer polymerization requires elevated temperature, it also has a significant moisture evaporation effect that further increases shrinkage. It can lead to increased cracking and reduced service life of the structures. Due to this concern, for long-term strain reduction, such as plastic and drying shrinkage and creep, fibre reinforcement is added to constrain the development of stresses in the material. This research aims to determine how different fibre reinforcements would impact geopolymer composites creep and shrinkage strains. Specimens for long-term property testing purposes were prepared with 1% of steel fibres, 1% polypropylene fibres (PP), 0.5% steel and 0.5% polyvinyl alcohol fibres, 5% PP fibres, and without fibres (plain geopolymer). The lowest creep strains are 5% PP fibre specimens, followed by 1% PP fibre, plain, 0.5% steel fibre and 0.5% PVA fibre, and 1% steel fibre specimens. The lowest specific creep is to 5% PP fibre reinforced specimens closely followed by 1% PP fibre followed by 0.5% steel and 0.5% PVA fibre, plain and 1% steel fibre reinforced composites. Specimens with 0.5% steel and 0.5 PVA fibre showed the highest compressive strength, followed by 1% PP fibre specimens, plain specimens, 1% steel fibre, and 5% PP fibre reinforced specimens. Only specimens with 1% PP fibre and 0.5% steel, and a 0.5% PVA fibre inclusion showed improved mechanical properties. Geopolymer concrete mix with 1% PP fibre inclusion and 0.5% steel and 0.5% PVA fibre inclusion have a 4.7% and 11.3% higher compressive strength. All the other fibre inclusion into mixes showed significant decreases in mechanical properties.
Databáze: OpenAIRE
Externí odkaz: