Study on fabrication and cutting performance of high quality diamond coated PCB milling tools with complicated geometries
| Autor: | Fanghong Sun, Bin Shen, Z.M. Zhang, H. G. Xue, Ming-Yun Chen |
|---|---|
| Rok vydání: | 2009 |
| Předmět: |
Engineering drawing
Materials science Fabrication Glass fiber Diamond Surfaces and Interfaces Chemical vapor deposition Edge (geometry) engineering.material Condensed Matter Physics Grain size Surfaces Coatings and Films Printed circuit board Materials Chemistry engineering Composite material Layer (electronics) |
| Zdroj: | Surface Engineering. 25:70-76 |
| ISSN: | 1743-2944 0267-0844 |
| DOI: | 10.1179/026708408x334140 |
| Popis: | The diamond film was deposited on a complex shaped WC–Co printed circuit board (PCB) milling tool in a revised hot filament chemical vapour deposition apparatus, in which the vertical spiral hot filament arrangement was adopted. The SEM investigation on the surface of the fabricated diamond coated PCB milling tool exhibited a continuous layer of fine grained diamond films, with grain size of about 2–3 μm, was uniformly deposited. To evaluate the cutting performance of the fabricated diamond coated tool, comparative milling tests were conducted for both diamond coated and uncoated WC–Co PCB milling tools, with glass fibre reinforced composite materials as the workpiece. The milling test results showed that the flank wear on circle and end cutting edge of the fabricated diamond coated PCB milling tool were only 0·08 and 0·18 mm respectively after 40 min milling, about one-fifth and a quarter of that for uncoated WC–Co PCB milling tool, which could attribute to both the good wear resistance of the d... |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|