Laser micromachining for fatigue and fracture mechanics applications
| Autor: | Mool C. Gupta, B. Li, S. Gadag, K.C. Chou |
|---|---|
| Rok vydání: | 2010 |
| Předmět: |
Materials science
Mechanical Engineering Laser beam machining Stress–strain curve Titanium alloy Fracture mechanics Atomic and Molecular Physics and Optics Electronic Optical and Magnetic Materials Stress (mechanics) Fracture (geology) Cylinder stress Tube (fluid conveyance) Electrical and Electronic Engineering Composite material |
| Zdroj: | Optics and Lasers in Engineering. 48:441-447 |
| ISSN: | 0143-8166 |
| Popis: | A laser micromachining (LMM) method to initiate flaws for fatigue and fracture mechanics applications is successfully demonstrated. Dynamic response of moving energy pulses during LMM of titanium alloy (Ti–3.5Al–2.5V) was numerically simulated by an integrated energy approach using temperature-dependent thermophysical properties and 3D heat transfer code. Stress and strain analyses were performed for a titanium tube of 9.53 mm outer diameter (OD) and 0.81 mm wall thickness (WT) with a 0.23 mm deep and 1.83-mm-long longitudinal laser micro-machined notch, using nonlinear finite element analysis (FEA). For comparison, an electric-discharge-machined (EDM) notched tube with the same notch profile as the laser-prepared tube was also investigated. The calculated hoop stress and strain amplitudes at the notch root of the EDM-prepared tube were approximately 64% and 63% of the stress and strain amplitudes in the laser-prepared tube, respectively, when two tubes were subjected to inner pressures for R ratio of 0.03 and ΔP=45, 50, and 55 MPa. Fatigue life due to crack initiation process can be minimized using LMM method. The described LMM method is, therefore, more appropriate than EDM for accomplishing flaw formation to study fatigue and fracture behavior of various materials. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect