Control charts in multi-element analysis of human urine

Autor: A. Sorbo, Marina Patriarca, Augusto Alberto Pastorelli, Antonella Semeraro
Rok vydání: 2013
Předmět:
Zdroj: Accreditation and Quality Assurance. 18:307-312
ISSN: 1432-0517
0949-1775
Popis: A plan for internal quality control (IQC) was designed to monitor the quality of analytical results obtained from the simultaneous determination by ICP-MS of nine trace elements (As, Cd, Mo, Ni, Pb, U, V, W and Zr) in 1350 samples of human urine collected as part of an epidemiological study. Analytical performances, assessed during the method validation, were as follows: limit of quantification ranging from 0.002 μg/L (U) to 0.9 μg/L (Ni); recovery rates varying between 82 % (As) and 110 % (W); intermediate precision as relative standard deviation ranging from 2.5 % (Mo) to 14.2 % (V). Only for Zr, a significantly higher relative standard deviation was obtained. Initially, two commercially certified reference materials (CRMs) based on freeze-dried human urine and containing the elements of interest at suitable levels of concentration were used as control materials. However, due to considerations of reliability, convenience and cost, a control material based on fresh human urine was prepared in-house, evaluated by comparison with the CRMs and implemented for the IQC. The IQC strategy was as follows: at least one control material was analysed in each analytical session and one more control material was analysed after every ten urine samples. The central lines of the control charts were based on the assigned concentration values; the warning and action limits were set on a statistical basis, as two-times and three-times the value of the uncertainty of certified values or the observed standard deviation. At the end of the study, the data collected for the in-house control material were re-evaluated and confirmed its suitability for the purpose. The use of an in-house control material had important advantages: it was more representative of the test samples; its preparation did not involve additional steps, therefore, reducing the risk of contamination; the cost of implementing the IQC was also reduced. Some issues concerning the control charts for As and Mo were addressed and will be discussed.
Databáze: OpenAIRE
Externí odkaz: