Alloy modification for additive manufactured Ni alloy components Part II: Effect on subsequent machining properties

Autor: Lorenz Engelking, Dirk Schroepfer, Thomas Kannengiesser, Antonia Eissel, Kai Treutler, Volker Wesling
Rok vydání: 2022
Předmět:
Zdroj: Welding in the World. 67:1059-1066
ISSN: 1878-6669
0043-2288
Popis: Alloy 36 (1.3912) is an alloy with 36% nickel and 64% iron and is generally classified as a difficult-to-cut material. Increasingly complex structures and the optimization of resource efficiency are making additive manufacturing (AM) more and more attractive for the manufacture or repair of components. Subsequent machining of AM components is unavoidable for its final contour. By using modern, hybrid machining processes, e.g., ultrasonic-assisted milling (US), it is possible to improve the cutting situation regarding the resulting surface integrity as well as the cutting force. Part I deals with the influence of the alloying elements Ti, Zr, and Hf on the microstructure and the hardness of the initial alloy 36. Part II focusses on the effect of the alloy modifications and the ultrasonic assistance on machinability as well as on the surface integrity after finish-milling. The results show a highly significant influence of the ultrasonic assistance. The cutting force during the US is reduced by over 50% and the roughness of approx. 50% compared to conventional milling (CM) for all materials investigated. Moreover, the US causes a defect-free surface and induces near-surface compressive residual stresses. CM leads to a near-surface stress state of approx. 0 MPa.
Databáze: OpenAIRE
Externí odkaz: