| Popis: |
Carbon dioxide sequestration within the subsurface is an emerging field of research to mitigate the problem of increasing concentrations of atmospheric CO2. The onshore/nearshore Gippsland Basin in the state of Victoria, SE Australia, contains deep saline formations that have been identified as potential targets for CO2 storage. Intensive and careful examinations are to be carried out to evaluate these targets. Numerical simulations presented in this study, which were developed using ECLIPSE software, have been designed to investigate certain parameters that influence CO2 behaviour within the subsurface structures. Analysis of results from these simulations will ultimately aid the evaluation of the Gippsland Basin as a suitable prospect for CO2 storage.Parameters of interest are the ratio of vertical to horizontal permeability, injection rate and the location/depth of perforation. Each one was varied based on a typical range. A 30-year period of CO2 injection followed by a 70-year monitoring period was used as the timeframe for each simulation run. Results of this study indicate that high values of vertical to horizontal permeability are favourable from a trapping efficiency point-of-view. However, they are not appealing from a containment perspective because they enhance buoyant migration of CO2 towards the top seal resulting in a high possibility that ultimate containment will be lost. With respect to injection rate, altering the injection rate does not have apparent effects on trapping efficiencies, namely storage by dissolution and residual gas saturation trapping. Although high values are preferable for dealing with an increased storage volume of CO2, a critical point has to be emphasized. Simulation results suggest that high reservoir injectivity rates cause CO2 to travel faster under buoyancy towards cap rock. Low injection rate decreases the storage volume of CO2. Therefore, a prudent design of injection rate is critical in order to optimise these counterbalancing factors. Additionally, perforation of the lowest section of the reservoir maximises trapping and containment efficiency as far as the injection rate is not compromised. Further emphasis should be placed on improving the resolution, accuracy and thus, the reliability of the geological model as it will directly impact numerical simulation results. |
