Implementing Low-Diameter On-Chip Networks for Manycore Processors Using a Tiled Physical Design Methodology
| Autor: | Christopher Batten, Yanghui Ou, Shady Agwa |
|---|---|
| Rok vydání: | 2020 |
| Předmět: |
Computer science
020208 electrical & electronic engineering Bisection bandwidth 02 engineering and technology Parallel computing Timing closure Network topology Chip 020202 computer hardware & architecture 0202 electrical engineering electronic engineering information engineering Physical design Macro Latency (engineering) Electronic circuit |
| Zdroj: | NOCS |
| Popis: | Manycore processors are now integrating up to 1000 simple cores into a single die, yet these processors still rely on high-diameter mesh on-chip networks (OCNs) without complex flow-control nor custom circuits due to three reasons: (1) manycores require simple, low-area routers; (2) manycores usually use standard-cell-based design; and (3) manycores use a tiled physical design methodology. In this paper, we explore mesh and torus topologies with internal concentration and/or ruche channels that require low area overhead and can be implemented using a traditional standard-cell-based tiled physical design methodology. We use a combination of analytical and RTL modeling along with layout-level results for both hard macros and a 3×3mm 256terminal OCN in a 14-nm technology for twelve topologies. Critically, the networks we study use a tiled physical design methodology meaning they: (1) tile a homogeneous hard macro across the chip; (2) implement chip top-level routing between hard macros via short wires to neighboring macros; and (3) use timing closure for the hard macro to quickly close timing at the chip top-level. Our results suggest that a concentration factor of four and a ruche factor of two in a 2D-mesh topology can reduce latency by over 2× at similar area and bisection bandwidth for both small and large messages compared to a 2D-mesh baseline. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|