UASFF start-up for biohydrogen and biomethane production from treatment of Palm Oil Mill Effluent
Autor: | Nuruol Syuhadaa Mohd, Mahmoud Danaee, Shaliza Ibrahim, Bidattul Syirat Zainal, Ali Akbar Zinatizadeh, Azam Akhbari, Parviz Mohammadi |
---|---|
Rok vydání: | 2019 |
Předmět: |
Renewable Energy
Sustainability and the Environment Continuous operation Energy Engineering and Power Technology 02 engineering and technology 010402 general chemistry 021001 nanoscience & nanotechnology Condensed Matter Physics Start up Pulp and paper industry 01 natural sciences Palm oil mill effluent 0104 chemical sciences Fuel Technology Pome Biogas Bioreactor Environmental science Biohydrogen 0210 nano-technology Methane gas |
Zdroj: | International Journal of Hydrogen Energy. 44:20725-20737 |
ISSN: | 0360-3199 |
DOI: | 10.1016/j.ijhydene.2018.07.037 |
Popis: | A start-up study was conducted to produce biohydrogen and biomethane from Palm Oil Mill Effluent (POME) using a two-stage up-flow anaerobic sludge fixed-film (UASFF) bioreactor. 100% molasses was used to start the system, and POME was added at 10% increments until it reached 100% after 59 days. During this period of continuous operation, the HRT and temperature were adjusted in order to optimize the condition for biogas production. Hydrogen and methane gas production fluctuated between 53–70% and 90–95%, respectively, in the last four days of operation (days 56–59), with POME percentage being increased from 70% to 100% (30%–0% molasses). Using 100% raw POME led to a total COD removal of 83.70%, average gas production rates of 5.29 L H 2 d −1 (57.11% H 2 ) and 9.60 L CH 4 d −1 (94.08% CH 4 ), in their respective units. This output is comparable to, if not better than using 100% molasses as substrate. This work concludes that based on the relative consistency of biogas production on days 56–59, the two-stage UASFF bioreactor operating at a final HRT of 4 h and temperature of 43 °C has taken a period of two months for start-up. |
Databáze: | OpenAIRE |
Externí odkaz: |