| Autor: |
Rodolfo Radillo, Byron Rubio, Roberto Salas-Zuñiga, Hugo Vega, Omar Mendoza, Julio Hernandez, Mario Villalón, Ulises Reyes-Zamora, Alejandro Manzano-Ramírez, José Luis Reyes-Araiza, Nahary Montoya |
| Rok vydání: |
2015 |
| Předmět: |
|
| Zdroj: |
Key Engineering Materials. 668:137-144 |
| ISSN: |
1662-9795 |
| DOI: |
10.4028/www.scientific.net/kem.668.137 |
| Popis: |
The use of natural fibers has a great interest due to their damping properties, low density and moderate strength. The effect of incorporating chopped natural fibers, as disperse reinforced phase, on the dynamic or quasi-static elastic modulus of glass fiber laminates is presented. Squares of 32 cm2 plain wave glass fiber prepreg with epoxy resin were used in a stacking sequence [0]4. Short length chopped (1-3 mm) natural coir fiber was placed in between of each glass fiber prepreg sheet (4) and laminates were prepared by the vacuum bag technique. The volume fraction of natural fiber was 30% (mass fraction of 10%) and samples of 254 mm length and 25.4 mm width were cut and tested at vibration conditions in a cantilever beam arrangement. The vibration frequency was measured by an accelerometer ADXL335 at z-axis, perpendicular to the sample test plane and the elastic modulus was estimated with the cantilever model. The results showed that the samples with coir fiber showed an increase in the dynamic elastic modulus value of 150 to 171% with regard to that one of glass fiber samples without fiber. Standard Test Method for Tensile Properties of Polymer Matrix Composite Materials (ASTM D3039) was also used to further characterize the thin samples (≈0.75 mm) with an Instron machine 8800, 25kN. The tensile properties obtained are lower for coir fiber samples than the ones without. |
| Databáze: |
OpenAIRE |
| Externí odkaz: |
|
