Tree Felling with a Drill Cone
| Autor: | Christian Knobloch, Lars Richter, Jörn Erle |
|---|---|
| Rok vydání: | 2023 |
| Předmět: | |
| Zdroj: | Croatian journal of forest engineering. 44 |
| ISSN: | 1848-9672 1845-5719 |
| Popis: | Motor-manual timber felling is one of the most dangerous operations in the forest and cannot be completely replaced by fully mechanized timber harvesting by a harvester when dealing with large and deciduous trees. Shifting the center of gravity of tree ready to be felled beyond its tipping line using conventional felling wedges is dangerous because the forest worker is directly behind the stem and under the tree crown until just before the tree falls. The worker can be hit by the trunk itself, but also by falling parts of the crown. In a preliminary study for the development of a new type of felling head, felling with a drill cone that can open the felling cut with the help of an applied torque was investigated. A drill cone does not require any special cutting technique, no counter forces to the tree, works without impulses, it is self-retaining and can be unscrewed again.In order to determine the torque required for felling the tree as a function of the tree parameters, the mathematical equation framework was established and practical experiments were used to determine the friction parameters and verify the calculations. The torque of the drill cone is used to bend the intact fibers of the hinge, shift the center of gravity of the tree in the direction of fall, and to overcome the friction of the drill cone on the felling cut. The effects of forward or backward leaning trees on the required torque can also be quantified. It has been shown that the efficiency of a drill cone is low, but this is compensated for by the high internal torque to lift ratio. The maximum measured input torque for felling trees with a felling diameter up to 55 centimeter was 100 Nm. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|