Manufacturing complex Al2O3 ceramic structures using consumer-grade fused deposition modelling printers
| Autor: | Manfred N. Partl, Christoph R. Müller, Lovro Gorjan, Frank Clemens, Fateme Sarraf, Nicholas A. Conzelmann, Lily D. Poulikakos |
|---|---|
| Rok vydání: | 2020 |
| Předmět: |
chemistry.chemical_classification
Materials science Mechanical Engineering Composite number Ethylene-vinyl acetate 02 engineering and technology Molding (process) Polymer 021001 nanoscience & nanotechnology 01 natural sciences Industrial and Manufacturing Engineering chemistry.chemical_compound Compressive strength chemistry visual_art 0103 physical sciences visual_art.visual_art_medium Ceramic Composite material 010306 general physics 0210 nano-technology Layer (electronics) Shrinkage |
| Zdroj: | Rapid Prototyping Journal. 26:1035-1048 |
| ISSN: | 1355-2546 |
| Popis: | Purpose This study aims to fabricate complex ceramic tetrahedron structures, which are challenging to produce by more conventional methods such as injection molding. To achieve this aim, thermoplastic-ceramic composite filaments were developed and printed with unmodified, consumer-grade, fused deposition modelling (FDM) printers instead. Design/methodology/approach Al2O3 ceramic powder was mixed with ethylene vinyl acetate polymer as a binder (50 Vol.- per cent) to form a filament with a constant diameter of 1.75 mm. After the printing and thermal treatment stages, the shrinkage and mechanical properties of cuboid and tetrahedron structures were investigated. Findings The shrinkage of the parts was found to be anisotropic, depending on the orientation of the printing pattern, with an increase of 2.4 per cent in the (vertical) printing direction compared to the (horizontal) printing layer direction. The alignment of the ceramic particle orientations introduced by FDM printing was identified as a potential cause of the anisotropy. This study further demonstrates that using a powder bed during the thermal debinding process yields sintered structures that can withstand twice the compressive force. Originality/value Ceramic FDM had previously been used primarily for simple scaffold structures. In this study, the applicability of ceramic FDM was extended from simple scaffolds to more complex geometries such as hollow tetrahedra. The structures produced in this study contain dense parts printed from multiple contiguous layers, as compared to the open structures usually found in scaffolds. The mechanical properties of the complex ceramic parts made by using this FDM technique were also subjected to investigation. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|