Hydrothermal synthesis of CuO and CeO2/CuO nanostructures: spectroscopic and temperature dependent electrical properties

Autor: Lucia M. Lepodise, Cosmas M. Muiva, Romang Bosigo, Alex T. Kuvarega
Rok vydání: 2021
Předmět:
Zdroj: Journal of Materials Science: Materials in Electronics. 32:7136-7152
ISSN: 1573-482X
0957-4522
DOI: 10.1007/s10854-021-05423-6
Popis: In this study, CuO and CeO2/CuO nanostructures were successfully synthesized via a hydrothermal route. The structure, morphology, composition and optical properties of these nanostructures have been studied using various techniques. X-ray diffraction (XRD) analysis showed the formation of monoclinic crystalline phase of CuO with a decrease in the crystallinity of the samples as the Ce content increased. Scanning electron microscopy (SEM) acquired images showing that increased Ce incorporation induces transformation of morphology from spherical to rod-like nanostructures. Energy-dispersive X-ray spectroscopy (EDS) mapping showed that Ce was homogeneously distributed onto the CuO matrix. UV/Vis/NIR spectrophotometer measurements depicted a blue shift in the bandgap from 2.0 to 3.5 eV for 0%-6% Ce and then 3.2 eV for 8% Ce. Brunauer Emmett Teller (BET) analysis revealed enhanced porosity with the incorporation of cerium. Raman spectroscopy results confirmed the presence of the $${A}_{g}$$ (296 cm−1), $${B}_{g}$$ (346 cm−1) and $${B}_{g}$$ (631 cm−1) modes belonging to CuO. The F2g Raman active mode observed at 454 cm−1 belongs to CeO2. Fourier transform infra-red (FTIR) measurements showed stretching vibrations of Cu–O. The CeO2/CuO samples exhibited enhanced temperature-controlled Dc conductivity with the 4% Ce sample showing the lowest activation energy, lowest Tmax (peak value of (dσ/dT)) and consequently the maximum conductivity peaking at a temperature of 503 K. The nature of conductivity was elucidated on the basis of the carrier hopping model.
Databáze: OpenAIRE
Externí odkaz: