| Autor: |
V. Olshanetskii, V. Pleskach |
| Rok vydání: |
2021 |
| Předmět: |
|
| Zdroj: |
Innovative Materials and Technologies in Metallurgy and Mechanical Engineering. :36-40 |
| ISSN: |
1607-6885 |
| DOI: |
10.15588/1607-6885-2021-2-6 |
| Popis: |
Purpose. Optimization of the method of design and calculation of the composite matrices of molds for the manufacture of products from powder materials. Research methods. Analysis of stresses in the walls of solid and composite thick-walled cylinders and their existing calculations. Results. The peculiarities of stress formation in the wall of solid and composite thick-walled cylinders under the action of internal pressure are investigated. The possibility of applying the obtained results to determine the strength and stiffness of the wall of the mold for the manufacture of products from powder materials is analyzed. Limitations in ensuring the strength of the matrix by only increasing its thickness are determined. It is shown that the use of a matrix composed of an inner cylinder and an outer holder allows to use optimal stress redistribution in the walls of such matrix in order to reduce the size and, accordingly, save materials for its manufacture. The possibility of using various, better adapted materials for the manufacture of the inner wall of the matrix and permiting the reduction of the cost of manufacturing the mold are analyzed. The method of calculation of stresses in dangerous points of walls of a matrix at an estimation of their strength and stiffness is generalized. Formulas for determination of the guaranteed tension which will provide effective redistribution of stresses in walls of the composite matrix under the set operating conditions are given. Scientific novelty. Approaches to the analysis of stresses in the walls of composite matrices of molds under the influence of internal pressure are optimized and generalized . Mathematical dependences are given, which make it possible to determine the optimal dimensions of mold elements at action of pressing pressure. Practical value. The principles of design and methods of calculation of composite matrices of molds for the manufacture of products from powder materials are proposed. |
| Databáze: |
OpenAIRE |
| Externí odkaz: |
|
