Non-destructive detection of surface-bond defects in carbon composite-strengthened concrete structures
| Autor: | Jens Wöstmann, Boris Milmann, Rosemarie Helmerich |
|---|---|
| Rok vydání: | 2014 |
| Předmět: |
Engineering
business.industry Mechanical Engineering Bond Composite number Ocean Engineering Building and Construction Structural engineering Geotechnical Engineering and Engineering Geology Durability law.invention law Nondestructive testing Non destructive Traffic load Ultrasonic sensor Hammer Safety Risk Reliability and Quality business Civil and Structural Engineering |
| Zdroj: | Structure and Infrastructure Engineering. 11:3-14 |
| ISSN: | 1744-8980 1573-2479 |
| DOI: | 10.1080/15732479.2013.879322 |
| Popis: | For almost 15 years, carbon fibre-reinforced polymer (CFRP) plates and sheets have been used for strengthening and repair of civil engineering structures. CFRP plates were applied to upgrade structures for change in use or increasing traffic load. CFRP laminates have also been used to repair deteriorated structures such as multi-storey parking or bridges. The execution quality and condition of the strengthening measure in terms of bond integrity were neither monitored nor tested systematically. Inspectors eventually applied simple hammer knocking during regular main inspection for subjective noise distinction as a measure for eventual insufficient bond. This paper presents the feasibility and the limitations of low-frequency transversal ultrasonic waves with dry-coupling point-contact sensors for inspection and defect detection between CFRP laminate and concrete surfaces. The German Centre of Competence in Civil Engineering (DIBt) has initiated a national research project [Helmerich et al. (2012). Condition analysis of bonded CFRP-applications on concrete structures by means of non-destructive testing [in German: Zustandsuntersuchung von CFK-Klebeverstarkungen an Betonbauteilen mittels zerstorungsfreier Prufung (ZfP)]. Final, internal project report], carried out at the Federal Institute for Materials Research and Testing (BAM), Germany. The aim of the project was to present a potential non-destructive testing method for bond defect detection as a measure for the durability of the strengthening system more than 10 years after application. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|