High-Temperature Silicon-on-Insulator Gate Driver for SiC-FET Power Modules
| Autor: | Marcelo Schupbach, Caleb Paul Gutshall, A.B. Lostetter, Homer Alan Mantooth, I. Escorcia-Carranza, Khoa Minh Phan, Bradley A. Reese, Javier Valle-Mayorga |
|---|---|
| Rok vydání: | 2012 |
| Předmět: | |
| Zdroj: | IEEE Transactions on Power Electronics. 27:4417-4424 |
| ISSN: | 1941-0107 0885-8993 |
| DOI: | 10.1109/tpel.2011.2182213 |
| Popis: | Silicon Carbide (SiC) power semiconductors have shown the capability of greatly outperforming Si-based power devices. Faster switching and smaller on-state losses coupled with higher voltage blocking and temperature capabilities make SiC an attractive semiconductor for high-performance, high-power-density power modules. However, the temperature capabilities and increased power density are fully realized only when the gate driver needed to control the SiC devices is placed next to them. This requires the gate driver to successfully operate under extreme conditions with reduced or no heat sinking requirements. In addition, since SiC devices are usually connected in a half- or full-bridge configuration, the gate driver should provide electrical isolation between the high- and low-voltage sections of the driver itself. This paper presents a 225°C operable, silicon-on-insulator (SOI) high-voltage isolated gate driver IC for SiC devices. The IC was designed and fabricated in a 1 μm, partially depleted, CMOS process. The presented gate driver consists of a primary and a secondary side which are electrically isolated by the use of a transformer. The gate driver IC has been tested at a switching frequency of 200 kHz at 225°C while exhibiting a dv/dt noise immunity of at least 45 kV/μs. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|