Qualitative Evaluation of Machined Surface of Aluminum Alloy AlCu4Mg1 Depend on Feed Rate
| Autor: | Zuzana Mitalova, Frantisek Botko, Jaroslav Vybostek, Andrej Bernat, Robert Čep, Michal Hatala, Miroslav Rimár |
|---|---|
| Rok vydání: | 2018 |
| Předmět: |
010302 applied physics
Materials science Industrial production Alloy Manufacturing organization chemistry.chemical_element Mechanical engineering 02 engineering and technology Surface finish engineering.material 021001 nanoscience & nanotechnology 01 natural sciences Industrial and Manufacturing Engineering Machined surface chemistry Aluminium 0103 physical sciences engineering Surface roughness 0210 nano-technology |
| Zdroj: | Manufacturing Technology. 18:201-207 |
| ISSN: | 2787-9402 1213-2489 |
| DOI: | 10.21062/ujep/78.2018/a/1213-2489/mt/18/2/201 |
| Popis: | Aim of the article is evaluation of surface quality parameters Rz and Ra after turning of aluminum alloy. Turning is one of the wide spread manufacturing technologies used in industrial production. Experiment was focused on researching of influence of various cutting conditions on machined surface. Main aim of this article is comparison of surface roughness parameters Ra and Rz depending on feed rate and tool nose radius. Investigation and finding of optimal cutting conditions is necessary for economy of manufacturing organization. Despite extensive research carried out in the area of turning, there is always room for new research. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|