Plastic Flow Verification in a Tool Cavity for Production of Test Sample for Wettability Solders Measurement
| Autor: | Martin Ridzon, Roman Kolenak, Maria Kapustova, Vladimir Simna, Róbert Sobota, Cristina Borzan, Jozef Bílik |
|---|---|
| Rok vydání: | 2020 |
| Předmět: |
Process equipment
Materials Science (miscellaneous) Process Chemistry and Technology Metallurgy General Engineering General Chemistry General Medicine Plasticity General Biochemistry Genetics and Molecular Biology Petrochemistry Materials Chemistry Production (economics) Wetting General Pharmacology Toxicology and Pharmaceutics Test sample |
| Zdroj: | Revista de Chimie. 71:107-112 |
| ISSN: | 2668-8212 0034-7752 |
| DOI: | 10.37358/rc.20.1.7820 |
| Popis: | The paper describes the structural design, simulation and proper manufacture of a tool for manufacturing of test samples in spherical form. This shape is essential for an innovative assessment of solder wettability, since the small sphere by its ideal shape represents the total non-wettability of substrate surface. In order to verify the design of the shaping tool, a simulation software, type Deform was used, which allowed the FEM analysis of plastic flow in the tool cavity. Just after successful computer simulation, a shaping tool was designed and then manufactured in laboratory conditions, thus the fabrication of test samples in spherical form was successfully tested. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|