Combustion and flame position impacts on shear layer dynamics in a reacting jet in cross-flow
| Autor: | Vedanth Nair, Matthew Sirignano, Benjamin L. Emerson, Timothy C. Lieuwen |
|---|---|
| Rok vydání: | 2022 |
| Předmět: | |
| Zdroj: | Journal of Fluid Mechanics. 942 |
| ISSN: | 1469-7645 0022-1120 |
| DOI: | 10.1017/jfm.2022.387 |
| Popis: | This study experimentally investigates reacting jets in cross-flow (RJICF), considering flame/shear layer offset, momentum flux ratio ( $J$ ) and density ratio ( $S$ ) effects. These results demonstrate that non-reacting JICF and RJICF can exhibit very similar or completely different dynamics and controlling physics, depending upon streamwise and radial flame location. Consistent with prior measurements of Getsinger et al. (Exp. Fluids, vol. 53 (3), 2012, pp. 783–801), spatial amplification rates of shear layer vortex (SLV) structures increased with decreasing $S$ for non-reacting cases. Similar $S$ dependencies exist for reacting cases in which the flame lay outside the jet shear layer, whose flow topology is also quite similar to non-reacting cases, albeit with reduced SLV growth rates. However, although the reacting cases have lower growth rates, these SLV structures ultimately reach approximately the same peak strength as in the non-reacting cases. Finally, the SLV decay rate in both non-reacting and reacting cases was found to similarly scale inversely with the initial SLV growth rate. As such, primarily inertial mechanisms govern SLV growth and decay for reacting cases where the flame lies outside the shear layer. In contrast, very different behaviour is exhibited by reacting cases where the flame lies inside the shear layer, where the locally increased viscosity exerts significant influences. In these reacting cases, SLV roll-up is completely suppressed and the entire jet column undulates over a long length scale relative to the jet diameter. As such, the relative roles of inertial and viscous mechanisms in controlling combustion influences on the SLV dynamics, changes markedly with shear layer–flame offset. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|