High-temperature tribological behavior of structural materials after conditioning in impure-helium environments for high-temperature gas-cooled reactor applications
| Autor: | David S. Grierson, Carter Tesch, Joseph Kern, Dileep Singh, Valentin Pauly, Kumar Sridharan, Malcolm Clark, Oyelayo O. Ajayi |
|---|---|
| Rok vydání: | 2019 |
| Předmět: |
Nuclear and High Energy Physics
Materials science Metallurgy Alloy chemistry.chemical_element 02 engineering and technology Tribology engineering.material 021001 nanoscience & nanotechnology 01 natural sciences 010305 fluids & plasmas Coolant Corrosion Nuclear Energy and Engineering chemistry 0103 physical sciences engineering General Materials Science 0210 nano-technology Inconel Helium Incoloy Tribometer |
| Zdroj: | Journal of Nuclear Materials. 522:311-323 |
| ISSN: | 0022-3115 |
| DOI: | 10.1016/j.jnucmat.2019.05.025 |
| Popis: | Incoloy 800HT and Inconel 617 have been selected as candidate structural alloys for the high-temperature gas-cooled reactor (HTGR) concept. Helium, the primary coolant, contains impurities (e.g., H2O and CH4) that can induce corrosion reactions at high temperatures, which in turn can affect the tribological behavior of components in sliding contact such as valves and control-rod drive systems. This paper presents results from the study of the tribological behavior of both alloys before and after conditioning them in either an impure-helium oxidizing environment or in an air environment. Both alloys were conditioned for 22 days at elevated temperatures in a once-through helium loop with 4 ppmv H2O and tested subsequently at elevated temperatures with a pin-on-disk tribometer in an air environment - 650 °C and 750 °C for 800HT; 850 °C and 900 °C for 617 – with various applied loads - 1 N, 2 N and 5 N. SEM-EDS analysis revealed that conditioning the samples in an oxidizing environment leads to the formation of a mixed Fe/Cr-oxide on alloy 800HT and a Cr-oxide on alloy 617, both increasing the wear resistance compared to that of as-received samples. Alloy 617 exhibited lower steady-state friction coefficients compared to those of alloy 800HT. There was a significant decrease in the scatter of the steady-state friction coefficient of the conditioned samples compared to that of the unconditioned samples. The steady-state friction coefficient for alloy 800HT and 617 were found to be 0.53 ± 0.07 and 0.25 ± 0.04, respectively. The wear resistance of alloy 800HT is approximately one order of magnitude lower than that of alloy 617 in all cases that exhibited measurable wear. After sample conditioning, the wear volumes measured at low loads were undistinguishable from the unworn background, a result attributed to the formation of a compacted glaze layer under high temperatures and high contact stresses. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect