Borehole heat exchanger with nanofluids as heat carrier
| Autor: | Maurizio Sasso, Giuseppe Diglio, Carlo Roselli, Umavathi Jawali Channabasappa |
|---|---|
| Rok vydání: | 2018 |
| Předmět: |
Materials science
Renewable Energy Sustainability and the Environment 020209 energy Nanofluids in solar collectors Plate heat exchanger Thermodynamics Geology 02 engineering and technology Heat transfer coefficient 021001 nanoscience & nanotechnology Geotechnical Engineering and Engineering Geology Thermal diffusivity Nanofluid Volumetric heat capacity Heat transfer Heat spreader 0202 electrical engineering electronic engineering information engineering Composite material 0210 nano-technology |
| Zdroj: | Geothermics. 72:112-123 |
| ISSN: | 0375-6505 |
| DOI: | 10.1016/j.geothermics.2017.11.005 |
| Popis: | This paper presents numerical study on the use of nanofluids to replace conventional ethylene glycol/water mixture as heat carrier in a BoreHole Heat Exchanger. Nanofluids contain suspended metallic nanoparticles: increasing their concentration, in comparison to the base fluid, the thermal conductivity increases and the volumetric heat capacity decreases. The first effect is positive for the reduction of borehole thermal resistance, since it causes the grow of fluid convective heat transfer coefficient, while the second one is detrimental, due that it decreases the heat transfer between fluid and borehole wall. A numerical model based on energy and momentum balances is used to evaluate which is the best nanofluid with low nanoparticles volumetric concentration (0.1%–1%) that ensures the highest decreases of borehole thermal resistance and minimum increases of pressure drop among silver, copper, aluminium, alumina, copper oxide, graphite and silicon oxide. Moreover, a simple economic analysis was done. Results show that copper is characterized by highest borehole thermal resistance reduction, that reaches the value of about 3.8%, in comparison to that of base fluid, when nanoparticles volumetric concentration is 1%, but also the second one highest pressure drop. In this case, the cost of copper-based nanofluid is about 10 € m−1, i.e. about 12% of total cost of BoreHole Heat Exchange – Ground Source Heat Pump system. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect