Anisotropic tensile and actuation properties of NiTi fabricated with selective laser melting

Autor: Peizhen Li, Mohammad Elahinia, Sayed Ehsan Saghaian, Haluk E. Karaca, Amirhesam Amerinatanzi, Guher P. Toker, Hamdy Ibrahim, Narges Shayesteh Moghaddam
Rok vydání: 2018
Předmět:
Zdroj: Materials Science and Engineering: A. 724:220-230
ISSN: 0921-5093
DOI: 10.1016/j.msea.2018.03.072
Popis: This study evaluates the anisotropic tensile properties of Ni50.1Ti49.9 (in at%) components fabricated using an additive manufacturing (AM) process of selective laser melting (SLM). Dog-bone shaped tensile specimens were fabricated in three orthogonal building orientations (i.e., horizontal, edge, and vertical) with two different scanning strategies (i.e., alternating x/y and alternating in ± 45° to the x-axis). Next, the samples were subjected to tensile testing until failure, shape memory effect tests and thermal cycling under constant tensile stresses up to 500 MPa. Their failure surfaces were analyzed for possible microstructural defects. It was revealed that the build orientation and scanning strategy affect the texture/microstructure, and hence the failure stress, ductility, shape memory effect, and functional stability. Samples fabricated in the horizontal orientation with alternating x/y scanning strategy had the highest ultimate tensile strength (606 MPa) and elongation (6.8%) with the strain recovery of 3.54% after 4 shape memory effect cycles. At stress levels less than or equal to 200 MPa, these samples had the actuation strain greater than 3.8% without accumulation of noticeable residual strain. It was observed that the scanning strategy of alternating in ± 45° result in degraded mechanical and shape memory response, particularly in horizontal and edge samples.
Databáze: OpenAIRE
Externí odkaz: