Autoignition and select properties of low sample volume thermochemical mixtures from renewable sources
| Autor: | Balakrishna Maddi, J. Timothy Bays, Molly O'Hagan, John C. Linehan, Evgueni Polikarpov, Mariefel V. Olarte, Daniel J. Gaspar, Karl O. Albrecht |
|---|---|
| Rok vydání: | 2019 |
| Předmět: |
Materials science
020209 energy General Chemical Engineering Organic Chemistry Analytical chemistry Energy Engineering and Power Technology Liquefaction Autoignition temperature 02 engineering and technology law.invention Hydrocarbon mixtures chemistry.chemical_compound Hydrothermal liquefaction Fuel Technology 020401 chemical engineering chemistry law 0202 electrical engineering electronic engineering information engineering Octane rating 0204 chemical engineering Cetane number Distillation Pyrolysis |
| Zdroj: | Fuel. 238:493-506 |
| ISSN: | 0016-2361 |
| DOI: | 10.1016/j.fuel.2018.10.115 |
| Popis: | Catalytic thermochemical processes can convert biomass-derived liquids into hydrocarbon mixtures that are potential liquid transportation blendstocks. However, few measurements of the autoignition behavior of these mixtures are reported in the open literature. Pacific Northwest National Laboratory reports on the autoignition behavior of 36 mixtures of catalytically upgraded liquids—including distillation fractions—from biomass liquefaction technologies. The technologies whose output was subsequently upgraded include direct routes (fast pyrolysis and hydrothermal liquefaction) and indirect routes (syngas to ethanol). The propensity of the biomass-derived hydrocarbons to autoignite was measured using an ignition quality tester (IQT) according to ASTM D6890 , which measures the time it takes a fuel-air mixture to autoignite under conditions relevant to cetane number measurements to yield a derived cetane number (DCN). This measurement was converted to a derived research octane number (dRON) using three empirical correlations reported in the literature (Kalghatgi et al., 2005; Naser et al., 2017; McCormick et al., 2017). The simulated distillation curve of each sample was measured using ASTM D2887 , and the autoignition behavior in different boiling range fractions was evaluated. Gas chromatography/mass spectrometry and 1H/13C nuclear magnetic resonance spectroscopy were used to determine the chemical composition of the liquids, and the impact on the research octane number of various functional groups present in the mixture was assessed. In general, aromatics and olefins enhanced octane number, in agreement with existing literature. The presence of esters was also found to increase dRON. The dRON method required smaller samples and gave an acceptable approximation of the research octane number measured using a certified fuel rating engine. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect