Abstract 4522: An optimized NGS workflow for detection of FLT3 internal tandem duplication (ITD) in AML samples

Autor: Xiaodong Wang, Weihua Liu, Zhenyu Yan, Cindy Spittle, Chad Galderisi, Jin Li, Peng Fang, Scott Glynn, Jennifer Biroschak
Rok vydání: 2018
Předmět:
Zdroj: Cancer Research. 78:4522-4522
ISSN: 1538-7445
0008-5472
Popis: FLT3 ITD, a prognostic marker and drug target, is present in ~19% of AML patients. FLT3 ITD is a tandem repeat of the entire or partial exon 13-15 region. FLT3 ITDs range in size from 3bp to above 300bp and impact RTK signaling. Recent publications have shown that FLT3 ITD can be detected at single nucleotide resolution by NGS panels. However, detection of large FLT3 ITD and accurate reporting of ITD frequency remain challenging for NGS methods. False negative ITD results or inaccurate mutant/wild type allele ratio measurements could negatively alter treatment decisions for AML patients. The Illumina TruSight Myeloid panel (TMP) is a commercial NGS assay that covers 54 genes involved in myeloid malignancies. Although the TMP assay can detect SBS and small indel, medium to large size FLT3 ITD cannot be detected. Here we present an enhanced workflow to overcome these challenges. Positive controls, dynamic range, accuracy, and inter-run reproducibility were validated for the detection of SBS, indel, and FLT3 ITD using reference standards and DNA extracted from cell lines and AML patient EDTA blood and bone marrow aspirate samples. NGS libraries were prepared following Illumina's standard protocol. 275bp X2 sequencing instead of the standard 150bp X2 was run on MiSeq flowcell v3. Data analysis was performed using a MolecularMD custom pipeline. The analysis of FLT3 ITD was conducted using three methods including two off-the-shelf programs, Pindel and ITDseek, as well as Cigar, a MolecularMD developed ITD detection algorithm. FLT3 ITDs at 126 bp and 21 bp in PL-21 and MOLM-13 cell lines, respectively, were detected by TMP assay using the three algorithms. In contrast to ITDseek which only reports ITD sequence without frequency information, Pindel and Cigar report both ITD sequence and frequency. Compared to Pindel, ITD frequency reported by the custom algorithm is closer to that determined by the fragment analysis. Serial dilution of the 126bp ITD into wild type DNA showed the 0.55% ITD (from fragment analysis) can be reproducibly detected at ~0.6% by the Cigar algorithm. FLT3 ITDs ranging in size from 6bp to 300bp were detected in clinical AML samples using the enhanced TMP workflow and confirmed by a fragment analysis method. Limit of detection, reproducibility and accuracy of SBS and indel detection in other key genes by the TMP assay have also been validated. Low-level mutations, i.e. NRAS G12D at 1.7%, NRAS G13D at 2%, and IDH2 R140Q at 1.4%, were detected by TMP panel from AML samples and further confirmed with an independent assay. A long deletion (52bp) in exon 9 of CALR was also detected by the custom pipeline. In summary, the enhanced TMP workflow allows for accurate detection and reporting of SBS, indel and FLT3 ITDs including large duplications. Optimized detection of FLT3 ITDs will improve AML patient selection for targeted therapy. Citation Format: Xiaodong Wang, Zhenyu Yan, Peng Fang, Weihua Liu, Scott Glynn, Jennifer Biroschak, Chad Galderisi, Cindy Spittle, Jin Li. An optimized NGS workflow for detection of FLT3 internal tandem duplication (ITD) in AML samples [abstract]. In: Proceedings of the American Association for Cancer Research Annual Meeting 2018; 2018 Apr 14-18; Chicago, IL. Philadelphia (PA): AACR; Cancer Res 2018;78(13 Suppl):Abstract nr 4522.
Databáze: OpenAIRE
Externí odkaz: