| Popis: |
Eleven /sup 233/U solution critical assemblies spanning an H//sup 233/U ratio range of 40 to 2000 and a bare metal /sup 233/U assembly have been calculated with the ENDF/B-IV and Hansen-Roach cross sections. The results from these calculations are compared with the experimental results and with each other. An increasing disagreement between calculations with ENDF/B and Hansen-Roach data with decreasing H//sup 233/U ratio was observed, indicative of large differences in their intermediate energy cross sections. The Hansen-Roach cross sections appeared to give reasonably good agreement with experiments over the whole range; whereas the ENDF/B calculations yielded high values for k/sub eff/ on assemblies of low moderation. It is concluded that serious problems exist in the ENDF/B-IV representation of the /sup 233/U cross sections in the intermediate energy range and that further evaluation of this nuclide is warranted. In addition, it is recommended that an experimental program be undertaken to obtain /sup 233/U criticality data at low H//sup 233/U ratios for verification of generalized criticality safety guidelines. Part II of this report presents the results of criticality calculations on specific pieces of equipment required for HTGR fuel refabrication. In particular, fuel particle storage hoppers and resin carbonization furnaces are criticality safemore » up to 22.9 cm (9.0 in.) in diameter providing water or other hydrogenous moderators are excluded. In addition, no criticality problems arise due to accumulation of particles in the off-gas scrubber reservoirs provided reasonable administrative controls are exercised.« less |
