Experimental Studies of the Discharge Characteristics of Variable-Pitch Multifinned Seals

Autor: E. A. E. Ahmed Mohamed, S. S. Dmitriev, B. N. Petrunin
Rok vydání: 2021
Předmět:
Zdroj: Thermal Engineering. 68:295-301
ISSN: 1555-6301
0040-6015
DOI: 10.1134/s0040601521030022
Popis: Variable-pitch multifinned seals (VPMS) have not hitherto found wide use in the steam turbines produced in Russia, although they are quite often used outside of Russia. In modernizing the existing and designing new steam turbines, rotor blades with an integrally machined shroud are used, which opens the possibility to manufacture multirow peripheral seals. In this connection, the question about selecting the optimal VPMS configuration becomes of important practical significance. The results obtained in this study made it possible to experimentally estimate the extent to which different combination of fin pitches on the rotor and stator influence the VPMS discharge characteristics and to elaborate practical recommendations on using them. The minimal leak flow was recorded for the VPMS models with a 2-mm-wide pitch on the rotor. Comparative experimental investigations of VPMS models with 3- and 4-mm-wide spacers on the rotor and 4- and 5-mm-wide spacers on the stator were carried out as applied to the shroud seals of large-capacity steam turbines. The model pair with the 4- and 5-mm-wide spacers on the rotor and stator, i.e., with the pitches equal to 4.8 and 5.8 mm on the rotor and stator, respectively, can be regarded as the most optimal of those investigated in this work. It has been shown experimentally that, with all other things being equal, the leak in VPMSs is by 22–25% smaller than it is in straight-flow seals. By using VPMS, it becomes possible to avoid rubbing of the rotor against the stator under the conditions of relative radial and axial rotor displacements in transient modes of operation. In addition, the aerodynamic forces in VPMS able to excite a low-frequency shaft line self-oscillation are approximately equal to 60% of the similar forces occurring in the conventional radial clearance seals. In view of this circumstance, VPMS can be recommended for use instead of the standard tip shroud seals in the high- and intermediate-pressure cylinders in new and modernized steam turbines.
Databáze: OpenAIRE
Externí odkaz: