The role of areal heat capacity and decrement factor in case of hyper insulated buildings: An experimental study
| Autor: | Marianna Pergolini, Francesca Stazi, Giulia Ulpiani, C. Di Perna |
|---|---|
| Rok vydání: | 2018 |
| Předmět: |
Brick
020209 energy Mechanical Engineering Thermal resistance Microclimate 02 engineering and technology Building and Construction Heat capacity Insulation layer Test room Thermal 0202 electrical engineering electronic engineering information engineering Environmental science Electrical and Electronic Engineering Composite material Envelope (mathematics) Civil and Structural Engineering |
| Zdroj: | Energy and Buildings. 176:310-324 |
| ISSN: | 0378-7788 |
| Popis: | Extensive simulation-based researches have highlighted the importance of placing a massive layer in the inner side of hyper insulated CLT buildings in the interest of optimize their thermal performance on an annual basis. The purpose of the present research is to experimentally evaluate the thermal responsiveness of multi layered and highly insulated CLT building envelopes characterized by different combination of two dynamic parameters, namely the internal areal heat capacity κ1 and the decrement factor f. An on-site monitoring campaign was extensively performed, during summer and winter seasons, on an unoccupied and windowless test room in Central Italy. Four internal linings were simultaneously tested on the south facing wall: plasterboard (as a baseline reference), two dry clay panels with different thickness and a combination of brick and an additional internal insulation layer. Over the year, the indoor microclimate was exposed to three different occupancy/solar gains profiles, identified with Test 1–3 and supplied to the room by three electric radiators. During Test 1 and Test 2 (summer and autumn, respectively), the results have shown the limits of the adoption of lightweight and hyper-insulated external walls with high internal areal heat capacity and very low decrement factor in the Mediterranean area. In fact, such typology exhibits the highest surface temperatures, with daily maximum around 28 °C and nocturnal minimum approximately 1.5 °C lower. Moreover, increasing the thermal resistance of a wall by adding an insulated lining partially inhibits the proper storage ability on the inner side, causing the release of more heat inside the test room. Conversely in winter (Test 3), such configuration was found to have a positive response in terms of stored heat quota, with respect to the released one. The solution that guaranteed the best thermal performance on annual basis under different indoor boundary conditions was the wall envelope characterized by average inertial properties, notably κ1 equal to 33 kJ/(m2K) and a decrement factor of 0.072. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect