| Popis: |
Design of asphalt mixes and quality testing is influenced by the laboratory compaction procedure. Laboratory specimens must be manufactured in a way that suitably resembles field compaction for a performance test to give reliable mechanical properties. The internal structure of the mixture, which is referred to in this article as the spread of aggregate and air voids, provides the basis for the simulation. Gyratory compaction uses a kneading effort to produce cylindrical specimens. The goal of the present article is to determine the required strength for asphalt mix compaction of 40–50 per surface. This look was achieved with three distinct types of filler material and two kinds of sand. The asphalt mixture’s compressibility was tested. By adding the cumulative energy expended during gyratory specimen compaction to the compression data, the force applied to the sample during gyrations may be calculated. The relation between the number of gyrations and forces demonstrates pressure resistance. The measured fore force vs number of gyrations for combinations containing limestone, cement, and fly ash as fill materials was presented. The force required to compact the six bituminous materials was found to be influenced by the filler content. As the number of gyrations increases, its compaction properties change until it achieves a steady state. Except for the asphalt–cement mixture, compaction strength in mixes containing river sand requires less strength than compaction strength in mixes containing crushed sand. |
