| Popis: |
In this work an original installation (manipulator) has been created that allows one to obtain up to 30 samples of hollow fiber membranes in one molding cycle, while simultaneously varying the molding conditions in a wide range (polymer concentration, nature of solvent and precipitant, exposure time in air and in a precipitant environment, post-processing and washing modes samples, diameter of the carrier needle). This installation makes it possible to move to a fundamentally higher level of accumulation of experimental data on the relationship "the composition of the spinning solution - the structure of the hollow fiber membrane - the separating properties of the membrane." It will also make it possible to involve in these studies new laboratory samples of polymers whose synthesis volumes are insufficient for the existing methods of obtaining laboratory samples of hollow fiber membranes. The principle of operation of the manipulator was worked out when obtaining mini-samples of hollow fiber PSF membranes from 24 wt. % PSF solution in NMP with the addition of 19 wt. % PEG-400 blowing agent on a carrier needle with external deposition. Mini-samples were obtained for studies of morphology, mechanical, transport and separation properties in one molding cycle of the manipulator. The properties of mini-samples of hollow fiber PSF membrane were compared with the properties of a membrane made by the method of “dry-wet” molding with internal deposition from a solution of the same composition. It was found that the porous structures of the membranes differ significantly from each other. In a hollow fiber PSF membrane obtained on a manipulator, the porous structure was spongy with separate macrovoids of various shapes. However, in the membrane obtained by the “dry-wet” method, a dense selective layer was formed on the inner side of the backing layer of elongated finger-shaped pores. It is the formation of spongy pores along the entire perimeter of the fiber wall that led to a decrease in the permeability of the hollow fiber PSF membrane obtained on the manipulator. Thus, not only the composition of the solution, but also the molding method makes a significant contribution to the properties of the membrane. |
