Viscoelastic properties of thermo-hydro-mechanically treated beech (Fagus sylvatica L.) determined using dynamic mechanical analysis

Autor: Jane O'Dell, Matthew Schwarzkopf, Frederick A. Kamke, Christopher G. Hunt, Andreja Kutnar, Charles R. Frihart
Rok vydání: 2020
Předmět:
Zdroj: European Journal of Wood and Wood Products. 79:263-271
ISSN: 1436-736X
0018-3768
Popis: Thermo-hydro-mechanical (THM) processing can improve the intrinsic properties of wood, produce new materials, and give desired form and function to new applications. THM treatments change the mechanical properties of wood and may change its viscoelastic properties as well. Therefore, the objective of this study was to assess the viscoelastic properties of THM-treated wood at several humidity and load levels. To explore these changes, this study applied a THM treatment to beech (Fagus sylvatica L.) wood with steam (620 kPa) and heat (170 °C), followed by densification and increased temperature (200 °C) in a hot-press, which was then cooled while under pressure. Two initial specimen thicknesses before THM treatment were used to study the difference between density ratios. Specimens were tested in a humidity-controlled dynamic mechanical analyser (DMA) to apply creep stress with different loading levels (20% and 30% of expected modulus of rupture) and relative humidity levels (30%, 50%, and 65% RH). The creep compliance/recovery response was monitored, and dynamic moduli were measured before and after the application of creep stress. The loss modulus measured was highest for specimens tested at 65% RH and lowest in specimens tested at 30% RH, which is a direct result of the viscous response of the material. Increased damping of the specimens was also observed at higher RH, which is typical for wood products due to added moisture in the cell wall acting as a plasticizer to cell wall polymers. Like previous studies, THM treatment lowered the equilibrium moisture content (EMC) of densified wood specimens, which affected their mechanical performance. THM treatment yields higher strength and lower EMC, suggesting that this product could be suitable for structural applications where their service life is in an indoor environment. THM treatment also resulted in decreased creep compliance and recovery compliance as compared to control specimens.
Databáze: OpenAIRE
Externí odkaz: