Defect generation and analysis in mechanically alloyed stoichiometric Fe–Ni alloys

Autor: Kelvin G. Lynn, Mark A. Koten, Marc H. Weber, Yunlong Geng, Jeffrey E. Shield, Tursunjan Ablekim
Rok vydání: 2015
Předmět:
Zdroj: Journal of Alloys and Compounds. 633:250-255
ISSN: 0925-8388
DOI: 10.1016/j.jallcom.2015.02.038
Popis: FeNi, with the chemically-ordered L10 tetragonal structure, is a promising material for next-generation rare-earth-free permanent magnets. Due to the extremely low atomic Fe and Ni mobility below the critical chemical order/disorder temperature of 320 °C, no conventional metallurgical methods are able to induce its formation. Diffusion rates could be enhanced with the creation of excessive vacancies. High-energy mechanical alloying was employed to produce a nanocrystalline Fe–50 at.%Ni alloy. The high energy mechanical milling is expected to change the defect characteristics that would be used to study the effect that mechanical alloying has on the defect concentrations. X-ray diffraction revealed that over the entirety of the milling period, the Fe and Ni powders formed an fcc solid solution. The Williamson–Hall equation and Scherrer equation revealed that reductions in grain sizes were caused during alloying. The initial increase in internal strain, and by extension dislocations, was followed by a decrease in strain with further alloying, which was due to the combination effect of creation of dislocation from mechanical deformation and annihilation of dislocations at increasing grain boundaries. Doppler broadening positron annihilation spectroscopy (DB-PAS) showed that the overall number of open-volume defects decreased with increased milling time. Finally, changes of relative permeability, for the mechanically alloyed FeNi phase, were explained by the pinning effect of dislocations.
Databáze: OpenAIRE
Externí odkaz: