Evaluation of Different Neutralization Reagents in the Selective Removal of Impurities in Rare Earth Sulfuric Liquor
| Autor: | Ruberlan Gomes Silva, Carlos Antonio Morais, Eder Domingos de Oliveira |
|---|---|
| Rok vydání: | 2019 |
| Předmět: |
Magnesium
Mechanical Engineering Sodium Metals and Alloys chemistry.chemical_element General Chemistry engineering.material Raw material Geotechnical Engineering and Engineering Geology chemistry.chemical_compound chemistry Control and Systems Engineering Sodium hydroxide Impurity Reagent Materials Chemistry engineering Sulfate Nuclear chemistry Lime |
| Zdroj: | Mining, Metallurgy & Exploration. 37:65-78 |
| ISSN: | 2524-3470 2524-3462 |
| DOI: | 10.1007/s42461-019-00139-y |
| Popis: | The objective of this study is to assess the impact of different reagents, such as limestone, lime, magnesium oxide, and sodium hydroxide, in experiments carried out in the single purification step and in two consecutive purification steps by raising the pH of a rare earth sulfuric liquor with the aim to remove or reduce the impurity concentrations in the rare earth sulfuric liquor. The choice for the best purification condition was made based on the minimum loss of rare earth elements (REEs), reagent consumption, and residue generation. The exploratory experiments show that it takes place in the two consecutive purification steps, the first one consists in dosing the limestone pulp until it reaches a pH of 3.5 followed by an addition of a lime pulp reaching a pH of 5.0. Under this condition, the results were a total removal of Fe3+, PO43−, and Th4+ ions and a reduction of 99%, 87%, and 37% w/w in the Al3+, UO22+, and SO42− concentrations, respectively, in the purified rare earth liquor. Furthermore, the lowest REE losses (8.3% w/w) and reagent consumption (4.3 kg/m3) and also a low residue generation (7.5 kg/m3) were observed in this condition. Despite reaching similar results regarding impurity removal, the experiments done with the addition of limestone, lime, magnesium oxide pulps, and sodium hydroxide solution in the single purification step, where the pH was raised to 5.0, presented higher REE losses (64.9%, 42.5%, 44.8%, and 60.9% w/w, respectively) and a higher residue generation (43.2, 25.1, 11.1, and 13.6 kg/m3, respectively). This occurred due to the co-precipitation of salts containing rare earth elements in their composition. The experiments conducted with limestone, lime, and MgO resulted in a higher consumption of reagents, while the same result was observed when NaOH was used (4.3 kg/m3). In the experiments carried out with the addition of magnesium oxide and sodium hydroxide, the respective purified rare earth liquors presented a high concentration of magnesium, sulfate, or sodium, which could impact the quality of the marketable rare earth salts, whereas the salts obtained under the best condition observed in this study seem to be amenable for use as raw material in an attempt to obtain rare earth products with an acceptable chemical quality. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full text from SpringerLink