Size-dependent deformation mechanisms and strain-rate sensitivity in nanostructured Cu/X (X = Cr, Zr) multilayer films
| Autor: | Guoyu Zhang, Jun Sun, Gang Liu, Junshi Zhang, S.Y. Lei, J.J. Niu, Peng Zhang |
|---|---|
| Rok vydání: | 2012 |
| Předmět: |
Materials science
Polymers and Plastics Condensed matter physics Hexagonal crystal system Size dependent Metals and Alloys Nucleation Slip (materials science) Strain rate Microstructure Critical length Electronic Optical and Magnetic Materials Crystallography Deformation mechanism Ceramics and Composites |
| Zdroj: | Acta Materialia. 60:3677-3689 |
| ISSN: | 1359-6454 |
| DOI: | 10.1016/j.actamat.2012.03.052 |
| Popis: | Hardness, activation volume and strain-rate sensitivity of Cu/Cr (face-centered cubic (fcc)/body-centered cubic) and Cu/Zr (fcc/hexagonal close-packed) nanostructured multilayer films have been systematically measured as a function of modulation period (L) and modulation ratio (η), respectively. Significant size effects were found for all the three plastic deformation characteristics, i.e. enhanced hardness and activation volume but reduced strain-rate sensitivity with decreasing the dimension length L. Microstructure evolution was statistically examined to rationalize these size dependences. It was crucially observed that abundant nanotwins existed in the Cu grains, though nanotwin formation was depressed with smaller L. This inverse size-dependent nanotwin formation is responsible for the reduction in strain-rate sensitivity, because the negative effect induced by the decreased nanotwins predominates over the positive effect coming from the raised interfaces/boundaries. A mechanistic model is modified to account for the interface effect as well as the nanotwin effect, which yields calculations of strain-rate sensitivity in broad agreement with the experimental results when L is larger than about 20 nm. Below this critical length size, there are discrepancies between the calculations and the experimental results, due to the change in deformation mechanism from dislocation nucleation/slip in confined layers to dislocation crossing interfaces. A confined layer slip model is also modified by considering the nanotwin strengthening to quantitatively describe the L-dependent hardness. In addition, the effects of constituent phases and their relative content on the activation volume and strain-rate sensitivity of NMFs are discussed with regard to variation in η. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect