The role of grain size and selected microstructural parameters in strengthening fully lamellar TiAl alloys

Autor: Dennis M. Dimiduk, Triplicane A. Parthasarathy, P. M. Hazzledine, M. G. Mendiratta, Sriram Seshagiri
Rok vydání: 1998
Předmět:
Zdroj: Metallurgical and Materials Transactions A. 29:37-47
ISSN: 1543-1940
1073-5623
DOI: 10.1007/s11661-998-0157-3
Popis: More than 5 years ago, wrought processing was first used to produce fully lamellar (FL) microstructures in TiAl alloys having grain sizes less than ≈400 µm. These alloys exhibit an improvement in overall balance of properties, especially at high temperatures. More recently, such microstructural forms led to exceptional yield strengths (500 to 1000 MPa at low temperatures) while maintaining attractive high-temperature properties. The improvements appeared to be related to an unusually high apparent sensitivity of strength to grain size. Studies reported an apparent value for the slope of the Hall-Petch (HP) plot approaching 5 MPa√m for FL gamma alloys, while that for single-phase or duplex microstructures is near unity. The present investigations examine the slope of the HP plot for FL microstructures, paying particular attention to the lamellar microstructural variables. Results show that the α 2 lamellar thickness and spacing and the γ lamellar thickness can vary over more than two orders of magnitude with typical process methods. These spacings influence the value of k y in the HP (grain size) relationship. Since they often change concomitantly with grain size in processing, they can give rise to a large scatter in the HP plot. The investigations also examine the flow behavior, glide barriers, and slip multiplicity for polysynthetically twinned (PST) crystals (the single-grain analogue of FL material), and then map this behavior into an explanation of the yield behavior of high-strength FL gamma alloys.
Databáze: OpenAIRE
Externí odkaz: