Relationship between tool tilt angle, shoulder plunge depth and process energy input for pin-less friction stir welded thin Ti-6Al-4V sheets
| Autor: | D. G. Hattingh, D. Bernard, A. B. Gili |
|---|---|
| Rok vydání: | 2019 |
| Předmět: | |
| Zdroj: | IOP Conference Series: Materials Science and Engineering. 655:012010 |
| ISSN: | 1757-899X 1757-8981 |
| DOI: | 10.1088/1757-899x/655/1/012010 |
| Popis: | This paper reports on the initial process development towards evaluating pin-less friction stir welding as a feasible alternative joining technology for Ti-6Al-4V sheets. Initial research results were derived from “bead on plate” welds with a pin-less tool on 3 mm Ti-6Al-4V sheets to assist with decision making for joining 1 mm Ti-6Al-4V sheets. The study evaluates the shared influence of tool tilt angle and shoulder plunge depth on weld profile and process energy input for a pin-less tool. An experimental approach was followed, performing bead on plate welds with three tool tilt angles (0°, 1° and 2°) respectively at shoulder plunge depths from 0.15 mm to 0.25 mm in 0.05 mm increments. From critically evaluating the hardness profile and heat effected area below the tool shoulder, the shared influence of tool tilt angle and shoulder plunge depth could be analysed to give an indication of the best parameter combination for performing solid state welds on 1 mm Ti-6Al-4V sheet. Additionally, the thinning effect on the weld region was evaluated and compared to welds made with a pin. Future work will include quantifying surface residual stresses on the material and the relationship these stresses exhibits with the varying tool tilt and shoulder plunge depth. This work will assist in selecting weld parameter combination that will minimize tensile residual stresses in critical areas. Knowledge gained from this study forms the basis for the overall process development for joining 1 mm Ti-6Al-4V sheets by pin-less friction stir welding. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|