Optimization of the cooling strategy during cryogenic milling of Ti-6Al-4 V when applying a sub-zero metalworking fluid

Autor: Kevin Gutzeit, Maximilian Berndt, Jonas Schulz, Daniel Müller, Benjamin Kirsch, Erik von Harbou, Jan C. Aurich
Rok vydání: 2022
Předmět:
Zdroj: Production Engineering. 17:501-510
ISSN: 1863-7353
0944-6524
DOI: 10.1007/s11740-022-01178-z
Popis: Due to an excellent ratio of high strength to low density, as well as a strong corrosion resistance, the titanium alloy Ti-6Al-4 V is widely used in industrial applications. However, Ti-6Al-4 V is also a difficult-to-cut material because of its low thermal conductivity and high chemical reactivity, especially at elevated temperatures. As a result, machining Ti-6Al-4 V is characterized by high thermal loads and a rapidly progressing thermo-chemical induced tool wear. An adequate cooling strategy is essential to reduce the thermal load and therefore tool wear. Sub-zero metalworking fluids (MWF) which are applied at liquid state but at supply temperatures below the ambient temperature, offer great potential to significantly reduce the thermal load when machining Ti-6Al-4 V. Within the presented research, systematically varied sub-zero cooling strategies are applied when milling Ti-6Al-4 V. The influences of the supply temperature, as well as the volume flow and the outlet velocity are investigated aiming at a reduction of the thermal loads that occur during milling. The milling experiments were recorded using high-speed cameras in order to characterize the impact of the cooling strategies and resolve the behavior of the MWF. Additionally, the novel sub-zero cooling approach is compared to a cryogenic CO2 cooling strategy. The results show that the optimized sub-zero cooling strategy led to a sufficient reduction of the thermal loads and does outperform the cryogenic cooling even at elevated CO2 mass flows.
Databáze: OpenAIRE
Externí odkaz: