| Autor: |
Martín Salazar-Pereyra, Angélica E. Bonilla-Blancas, Daniel Enrique Reyes-Castrejon, Eduardo Figueroa-Estrada |
| Rok vydání: |
2019 |
| Předmět: |
|
| Zdroj: |
Revista de Ingeniería Mecánica. :1-6 |
| ISSN: |
2531-2189 |
| DOI: |
10.35429/jme.2019.10.3.1.6 |
| Popis: |
The manufacture of plastic products in the current markets demands the use of technologies that allow the molding of components with highly complex geometries and every time the time to manufacture is reduced. The presence of subsystems for the molding and release of negative structures increases the complexity of the mould, as well as the time required for the manufacture and adjust of the mould, since it is traditionally used mechanisms with angular pins. In this work the design of an injection mould is made for a component with negatives, which uses a system with actuator for the secondary molding and release of the negative structure according to the mould partition line. The mold is also design for the same component with the use of a secondary system of moulding totally mechanical and of conventional use. The analysis of the design and operation between a secondary mechanical molding system and a system with actuator for molding and releasing negative structures in plastic injection molds, alternative for reducing costs and times of Manufacturing. |
| Databáze: |
OpenAIRE |
| Externí odkaz: |
|
