Variables governing the initial stages of the synergisms of ultrasonic treatment of biochar in water with dissolved CO2
| Autor: | Daniell L. Mattern, Chin-Pao Huang, Ruimei Fan, Adedapo Adeniyi, Baharak Sajjadi, Wei-Yin Chen, Joel Mobley |
|---|---|
| Rok vydání: | 2019 |
| Předmět: |
Aqueous solution
Hydrogen biology Chemistry Formic acid 020209 energy General Chemical Engineering Organic Chemistry Energy Engineering and Power Technology chemistry.chemical_element 02 engineering and technology Miscanthus biology.organism_classification Sonochemistry chemistry.chemical_compound Fuel Technology 020401 chemical engineering Environmental chemistry Mass transfer Biochar 0202 electrical engineering electronic engineering information engineering Heat of combustion 0204 chemical engineering |
| Zdroj: | Fuel. 235:1131-1145 |
| ISSN: | 0016-2361 |
| DOI: | 10.1016/j.fuel.2018.08.077 |
| Popis: | The objectives of a series of our researches are to determine the feasibility of applying ultrasonic pretreatment prior to biochar gasification. As per the initial results, the heating value (HV) of biochar significantly increased after acoustic treatment in water with dissolved CO2 (AIChE Journal, 2014;60:1054–1065). Accordingly, emphasis of the current work is placed on the parameters governing the HV of biochar in the early stage of the treatment. Switchgrass and miscanthus biochars were treated under different conditions. The reactant ratio, biochar:water:CO2, exhibited profound impacts on the synergism. The highest (but not yet systematically optimized) ratio of HV increase (or HV Gain, HG) to ultrasound energy supplied (ES) takes place when biochar-to-water ratio, or BC:W, equals 0.06 g/ml. The observed HG/ES is about 10, suggesting that the energy consumption is only a fraction of the acoustic energy supplied. Miscanthus biochar’s HV increases by up to 4.6% after treatment at 5% amplitude for 135 s (HG = 33 cal/g). For the same run, miscanthus biochar's H content increased by 42.7%. Changes in HV can be mediated by mineral leaching, C or H fixation, or O content loss. Mineral leaching is influenced by pH and CO2 concentration. CO2 and water are the sole contributors to C and H gains, respectively. CO2 concentration in the solution during the treatment is also affected by mass transfer limitations, ultrasound power, and design of the three-phase reactor. Increasing the BC:W ratio initially enhances the cavitation nuclei on the fluid/solid surface, and therefore sonolysis. The subsequent decrease in HV with increasing BC:W may be due to the limitation in ultrasound penetration and H supply from water. Carbon and hydrogen fixation may be connected to the formation of H2, CO, formic acid, formaldehyde, and associated radicals during sonolysis of aqueous CO2. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect