Processing and Properties of IM7/LARC ™ -RP46 Polyimide Composites
| Autor: | T H Hou, Ruth H. Pater, N J Johnston, S P Wilkinson, T L Schneiderk |
|---|---|
| Rok vydání: | 1996 |
| Předmět: |
Materials science
Polymers and Plastics Softening point Organic Chemistry 02 engineering and technology Composite laminates 021001 nanoscience & nanotechnology Critical transition Fracture toughness 020401 chemical engineering Rheology Materials Chemistry 0204 chemical engineering Composite material 0210 nano-technology Flow properties Isomerization Polyimide |
| Zdroj: | High Performance Polymers. 8:491-505 |
| ISSN: | 1361-6412 0954-0083 |
| DOI: | 10.1088/0954-0083/8/4/002 |
| Popis: | LARC™-RP46 resin system is a PMR type polyimide and is prepared by replacing methylenedianiline in the PMR-15 composition with 3,4′-oxydianiline. This resin system retains the same processing characteristics as PMR-15 but also offers enhanced fracture toughness. Rheological measurements were conducted on pre-imidized LARC™-RP46 moulding powder subjected to various ramp and hold temperature schemes. Adequate flow properties were found with theoretical (formulated) molecular weight 6 ≤1500 g mol−1. Critical transition temperatures for optimizing the process cycle were identified. They included the resin softening point, the imidization reaction peak, the isomerization reaction peak and the gelation point. Utilizing this information, 1.72 × 10 6 Pa (250 psi) cure cycles were designed for B-staged (dry) and unstaged (wet) prepregs. Composite laminates were fabricated which exhibited excellent consolidation and a void content below 0.1–0.2% as measured by image analysis. IM7/LARC™-RP46 exhibited higher composite mechanical properties than IM7/PMR-15. Short-beam shear strength, flexural strength and flexural modulus were measured at room temperature, 93, 150 and 177 °C. Composite engineering properties were also obtained including longitudinal tension, logitudinal compression, interlaminar shear, short block compression, open hole compression (OHC) and compression strength after impact (CAI). Excellent longitudinal tensile and compressive strengths were obtained and the CAI strength was 40% higher than that for PMR-15. Over 80% retention of all RT strengths were noted at 177 °C. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|