| Autor: |
M. Wieczorowski, B. Gapinski, A. Trytek, M. Konopacka |
| Jazyk: |
angličtina |
| Rok vydání: |
2010 |
| Předmět: |
|
| Zdroj: |
Archives of Foundry Engineering, Vol 10, Iss SI 1, Pp 269-272 (2010) |
| ISSN: |
1897-3310 |
| Popis: |
In the paper profilometric measurements of graphite casting elements were described. Basic topics necessary to assess roughness of their surfaces and influence of asperities on various properties related to manufacturing and use were discussed. Stylus profilometer technique of surface irregularities measurements including its limits resulting from pickup geometry and its contact with measured object were ana-lyzed. Working principle of tactile profilometer and phenomena taking place during movement of a probe on a measured surface were shown. One of the important aspects is a flight phenomenon, which means movement of a pickup without contact with a surface during inspection resulting from too high scanning speed. results of comparison research for graphite elements of new and used mould and pin composing a set were presented. Using some surface roughness, waviness and primary profile parameters (arithmetical mean of roughness profile heights Ra, biggest roughness profile height Rz, maximum primary profile height Pt as well as maximum waviness profile height Wt) a possibility of using surface asperities parameters as a measure of wear of chill graphite elements was proved. The most often applied parameter is Ra, but with a help of parameters from W and P family it was shown, that big changes occur not only for roughness but also for other components of surface irregularities. |
| Databáze: |
OpenAIRE |
| Externí odkaz: |
|
