Structural health monitoring of a smart composite structure with a Time-of-Flight method
| Autor: | Chen, Xianlong, Meyer, Yann, LACHAT, Rémy, Ouisse, Morvan |
|---|---|
| Přispěvatelé: | Université de Technologie de Belfort-Montbeliard (UTBM), Franche-Comté Électronique Mécanique, Thermique et Optique - Sciences et Technologies (UMR 6174) (FEMTO-ST), Université de Technologie de Belfort-Montbeliard (UTBM)-Ecole Nationale Supérieure de Mécanique et des Microtechniques (ENSMM)-Université de Franche-Comté (UFC), Université Bourgogne Franche-Comté [COMUE] (UBFC)-Université Bourgogne Franche-Comté [COMUE] (UBFC)-Centre National de la Recherche Scientifique (CNRS), Roberval (Roberval), Université de Technologie de Compiègne (UTC), Laboratoire Interdisciplinaire Carnot de Bourgogne [Dijon] (LICB), Université de Bourgogne (UB)-Université de Technologie de Belfort-Montbeliard (UTBM)-Centre National de la Recherche Scientifique (CNRS), femto-st, dma |
| Jazyk: | angličtina |
| Rok vydání: | 2017 |
| Předmět: | |
| Zdroj: | Euro-Mediterranean Conference on Structural Dynamics and Vibroacoustics Euro-Mediterranean Conference on Structural Dynamics and Vibroacoustics, Apr 2017, Sevilla, Spain |
| Popis: | International audience; Smart composite structures with a fully distributed set of integrated piezoelectric transducers are used to demonstrate the feasibility of embedded Structural health monitoring (SHM). Indeed, the piezo ceramics elements have been directly integrated into the heart of the composite during the manufacturing process. Then, a Time-of-Flight method has been applied. This technique is based on the duration measurements of a wave propagation with a simple and low cost experimental setup. Integrated piezoelectric transducers are used for monitoring the behavior of the structure. In this research, special plates (with a piezo ceramics disk on each corner), made of glass fibre composite, are manufactured. Different kinds of damages are simulated on these plates, including holes with different diameters. Then a Time-of-Flight method is used for the SHM of these plates. Finally, the preliminary test results obtained on one plate are compared and discussed. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|