The influence of thermal modification on the machining properties of beech wood
| Autor: | Merhar, Miran, Šega, Bogdan, Gornik Bučar, Dominika |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2019 |
| Předmět: | |
| Zdroj: | Les, Vol 68, Iss 1, Pp 15-24 (2019) Les, vol. 68, no. 1, pp. 15-24, 2019. |
| ISSN: | 2590-9932 0024-1067 |
| Popis: | V delu smo analizirali vpliv termične modifikacije na obdelovalne lastnosti bukovine, kjer smo ocenjevali kakovost obdelane površine po operaciji skobljanja, rezkanja in struženja nemodificirane in modificirane bukovine. Po obdelavi smo površine vizualno ocenili z ocenami od 1 do 5, glede na napake zatrganih, lomljenih in dvignjenih vlaken ter podali povprečno oceno za vsako vrsto operacije kot tudi odstotek preizkušancev z različno vrednostjo podane ocene. Ugotovili smo, da je povprečna ocena termično modificirane bukovine pri skobljanju boljša v primerjavi z nemodificirano bukovino, vendar pa ANOVA analiza ni potrdila statistično značilnih razlik. Ravno tako ni statistične razlike pri rezkanju, medtem ko je pri struženju vpliv modifikacije statistično značilen, saj je kakovost površine termično modificirane bukovine bistveno boljša. Iz opravljene analize lahko sklepamo, da ima termična modifikacija pozitiven vpliv na kakovost obdelane površine bukovine. The work analyses the influence of thermal modification on the machining properties of beech wood, where the quality of the surface is evaluated after the operation of planing, routing and turning of unmodified and modified beech. After machining, the surface is visually assessed with grades from 1 to 5, with respect to defects of raised, fuzzy and torn grain. As a result an average grade for each type of operation is given, as well as the percentage of each grade. It has been found out that the average grades of thermally modified beech wood in planing were better compared to unmodified beech, but ANOVA analysis did not confirm differences between them. There was also no difference in routing, while in turning the influence of modification was significant, since the surface quality of the thermally modified beech was significantly better compared to that of unmodified beech. From the analysis it can be concluded that thermal modification has a positive effect on the quality of the machined surface. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|