| Autor: |
Nagata, Yoshihiro, Kato, Kiyotaka, Shishido, Takuma, Tsuchiya, Ao, Kitaoka, Sanji, Oshiro, Naoto, Nishi, Naomi, Nonaka, Naoki, Koike, Takayuki, Oike, Toshimitsu, Hayashi, Kenji, Kambe, Hiroshi, Okane, Toshimitsu, Muhammad, Khairi Faiz, Yoshida, Makoto |
| Zdroj: |
International Journal of Metalcasting; January 2024, Vol. 18 Issue: 1 p46-59, 14p |
| Abstrakt: |
Non-heat-treated Al–Mg-based die casting alloys have been developed for the structural parts of automobiles. In previous studies, alloy compositions with at least 1.0%Si have been proposed to reduce the hot tearing susceptibility (HTS). On the other hand, the increase in the Si content reduces the ductility. For some automotive body structures, Al–Mg alloy die castings with Si content exceeding 1.0% should not have the required ductility. This study aims to develop an Al–Mg alloy with both high ductility and low HTSby investigating the following three characteristics of an Al–4.5Mg–1.0Mn alloy with 0.2%Si added: (1) additional elements to reduce the HTS, (2) the associated mechanical properties (requirements for the automotive company: 0.2% proof stress ≥ 140 MPa and fracture elongation ≥ 15%), and (3) the mechanism of decreasing the HTS. It was revealed that the co-addition of 0.025%Sr, 0.08%Ti, and 0.016%B reduced the HTSwhen the hydrogen content of the melt was 0.5–1.0 mL/100 g Al. Furthermore, the 0.2% proof stress and fracture elongation of a lower link arm produced via HPDC with the above composition were found to achieve the requirements. It was also indicated that the mechanism of decrease in the HTSby the Sr addition should result from the decrease in the thermal tensile load due to the formation of hydrogen porosity at a lower solid fraction than that without Sr. It is suggested that when 0.025%Sr, 0.08%Ti, and 0.016%B are added to the Al–4.5Mg–1.0Mn–0.2Si alloy, non-heat-treated automotive structural parts with both high ductility and low HTSwill be obtained by high-pressure die casting. |
| Databáze: |
Supplemental Index |
| Externí odkaz: |
|
|
Nepřihlášeným uživatelům se plný text nezobrazuje |
K zobrazení výsledku je třeba se přihlásit.
|
