| Autor: |
Busch, Andreas, Schweinar, Kevin, Kampman, Niko, Coorn, Ab, Pipich, Vitaliy, Feoktystov, Artem, Leu, Leon, Amann-Hildenbrand, Alexandra, Bertier, Pieter |
| Zdroj: |
Geological Society, London, Special Publications; 2017, Vol. 454 Issue: 1 p15-38, 24p |
| Abstrakt: |
Porosity of shales is an important parameter that impacts rock strength for seal or wellbore integrity, gas-in-place calculations for unconventional resources or the diffusional solute and gas transport in these microporous materials. From a well section obtained from the Mont Terri Underground Rock Laboratory in St Ursanne, Switzerland, we determined porosity, pore size distribution and specific surface areas on a set of 13 Opalinus Clay samples. The porosity methods employed are helium-pycnometry, water and mercury injection porosimetry, liquid saturation and immersion, and low pressure N2sorption, as well as small-angle to ultra-small-angle neutron scattering (SANS–USANS). These were used in addition to mineralogical and geochemical methods for sample analysis that comprise X-ray diffraction, X-ray fluorescence, total organic carbon content and cation exchange capacity. We find large variations in total porosity, ranging from approximately 23% for the neutron-scattering method to approximately 10% for mercury injection porosimetry. These differences can partly be related to differences in pore accessibility, while no or negligible inaccessible porosity was found. Pore volume distributions between neutron scattering and low-pressure sorption compare very well but differ significantly from those obtained from mercury porosimetry: this is realistic since the latter provides information on pore throats only, and the two former methods on pore throats and pore bodies. Finally, we find that specific surface areas determined using low-pressure sorption and neutron scattering match well. |
| Databáze: |
Supplemental Index |
| Externí odkaz: |
|
