Estimation of Machining Error in Ball-End Milling of Hemispherical Surface Based on Measured Cutting Force

Autor: Shimana, Kenji, Kondo, Eiji, Yamashita, Shunichi, Kawano, Yoshihiro, Kawagoishi, Norio
Zdroj: Advanced Materials Research; September 2014, Vol. 1017 Issue: 1 p692-695, 4p
Abstrakt: For a cutting process using a low-rigidity end mill, it is very important to be able to estimate the degree of machining error caused by the deflection of the tool. The purpose of this study is to establish a method of estimating, in real time, the machining error caused by the deflection at the cutting point of an end mill. To this end, in this research, a method for estimating the machining error caused by the deflection of the tool used for the ball-end milling of a hemispherical surface was verified by comparing the estimated and measured deflections of the tool. As a result, it was found that the machining errors in ball-end milling could be estimated from the normal force at the moment when the radial direction of the peripheral cutting edge is normal to the feed direction of the tool.
Databáze: Supplemental Index