| Autor: |
Weiss, I., Froes, F. H., Eylon, D., Welsch, G. E. |
| Zdroj: |
Metallurgical and Materials Transactions A; November 1986, Vol. 17 Issue: 11 p1935-1947, 13p |
| Abstrakt: |
The modification of lamellar alpha phase in Ti-6A1-4V by hot working was investigated with the aim of controlling morphology (aspect ratio) and final grain size. The effect of strain was studied using forging at 955 °C (1750 °F), followed by annealing at 925 °C (1700 °F) to allow the alpha morphology to adjust. Increasing the deformation from 6.5 pct to 80 pct reduction caused the lamellar alpha morphology to become progressively more equiaxed upon annealing. TEM observations showed that annealing of material deformed to 6.5 pct resulted in recovery of the alpha, without a noticeable change in the morphology, while higher deformation resulted in plate shearing and beta cusp formation. It was found that material with an initial thin alpha plate structure (thickness — 3.4 ώm) breaks up at a lower critical strain than a material with a thicker plate morphology (thickness ≃ 6 μm). The material with thin alpha plates more rapidly forms equiaxed alpha grains separated by beta phase, while the material with a thicker plate structure exhibits more alpha/alpha boundaries after deformation and annealing. The morphology change from alpha lamellae into lower aspect ratio grains was identified to be by a break-up of the alpha lamellae, essentially by a two-step process: a formation of low and high angle alpha/alpha boundaries or shear bands across the alpha plates followed by penetration of beta phase to complete the separation. This break-up takes place during hot deformation and subsequent annealing. |
| Databáze: |
Supplemental Index |
| Externí odkaz: |
|
Full text from SpringerLink