| Autor: |
Deng, G.J., Soo, S.L., Hood, R., Marshall, K., Mantle, A.L., Novovic, D. |
| Zdroj: |
Procedia CIRP; 2024, Vol. 123, p398-403, 6p |
| Abstrakt: |
Powder metallurgy (PM) processed nickel-based superalloys are increasingly employed in the hot section of gas turbine engines for parts such as high-pressure (HP) compressors and turbine rotor discs over more traditional cast and wrought options such as Inconel 718 due to its improved high-temperature properties. In this paper, the surface integrity and geometrical/dimensional accuracy of holes initially rough drilled using worn tools and subsequently finish plunge end milled in a proprietary PM-processed Ni-based superalloy, were assessed and compared. The influence of tool wear on hole quality after finish plunge end milling was also investigated. Significant improvement in hole quality was evident following finishing with reductions in surface roughness (up to ~86%), subsurface microhardness (up to ~125 HK 0.05) and workpiece microstructure deformation/damage (up to ~80% in terms of average depth) compared to corresponding rough drilled holes. Evidence of chatter marks on holes machined with worn plunge end mills was observed, despite exhibiting reduced surface roughness levels (~45-73%). Generally, somewhat improved hole surface integrity (reduced subsurface deformation by ~47-64%) and geometrical accuracy (circularity decreased by ~10-25%) were produced when employing new tools. [ABSTRACT FROM AUTHOR] |
| Databáze: |
Supplemental Index |
| Externí odkaz: |
|
