| Autor: |
BOGREKCI, I., DEMIRCIOGLU, P., SUCUOGLU, H. S., ALTUN, E., SAKAR, B., DURAKBASA, M. N. |
| Předmět: |
|
| Zdroj: |
DAAAM International Scientific Book; 2020, p099-112, 14p, 1 Chart |
| Abstrakt: |
The aim of this study is to analyze the impact of altered geometries on structural strength using static structural analysis. The tensile test specimens were created using solid state modelling in Autodesk Inventor Software and analysed with Siemens NX Software. Topology optimization was done in Autodesk Fusion 360. Certain amounts of incavation was applied. This is a significant improvement for weight-saving and complete design. After optimization, obtained data from first design were recorded and compared. Incavation parts were removed following topology optimization and then second design was created. Following the analysis of the second design, it was decided that a new design was needed. As a consequence, the third design was created. The analysis results of these three designs were compared with each other. As a result of the comparison, it was observed that the second design was 34.28% lighter than the original specimen. However, in the second design, regions with high stress values were existed. Therefore, the third design was created. The third design is 21.43% lighter than the original specimen, and the regions with high stress value have disappeared compared to the second design. Thus, the aim is achieved in terms of material savings. [ABSTRACT FROM AUTHOR] |
| Databáze: |
Supplemental Index |
| Externí odkaz: |
|
