| Abstrakt: |
In the realm of groundwater science, characterization of heterogeneous aquifers is pivotal for resolving diverse groundwater resource and engineering-related problems that require the detailed spatial distribution of hydraulic parameters. As research progresses, one hydraulic tomographical method, which is based on hydraulic travel time inversion, emerges as a promising and rapid method due to its robust and efficient calculation. In the field, the acquisition of hydraulic excitation and head observation data required for inversion is less time-consuming. Data collection from a single hydraulic test (such as a pumping test) typically takes only a few minutes or even a few tens of seconds. However, the field application of this method faces challenges. Hydraulic travel time is typically generated in the early stages of hydrogeological tests (e.g., early drawdown of a pumping test), yet accurate data may not be readily available because of the noise signals from test equipment, which can contaminate travel time signals, leading to inaccurate inversion results. A potential solution lies in utilizing the smooth head observation during the recovery period after the pump is turned off, which yields more accurate travel times for inversion calculations. In this paper, the mathematical development suggests that the travel time of the recovery phase aligns with that of the pumping phase when pumping reaches a steady or quasi-steady state. Subsequently, by employing Monte-Carlo simulations, 1200 realizations of two-dimensional heterogeneous confined aquifer models were generated for simulating pumping tests with different pumping durations. The calculated head data were then utilized to compute the travel time derived from drawdown data (t) and recovery data (t′), respectively. Comparisons showed that t is equal to t′ when drawdown reaches a steady or quasi-steady state. Conversely, when the pump is turned off before reaching a quasi-steady state, t differs from t′. However, results also indicate the fact that a decent hydraulic travel time diagnosis can be obtained, especially for the cases when travel times are smaller than 15 s. Given the statistical results of Monte-Carlo simulations, as well as experience during pumping tests in the field with different scenarios, using the recovery data from 60 s of pumping duration, or extended pumping durations of 100 s or 200 s as a more conservative alternative, can replace the aquifer characterization based on drawdown data. The new inversion strategy not only has less data uncertainty and equivalent inversion accuracy, but also can greatly enhance the repeatability of field tests and reduce the environmental impact of long-term pumping tests. [ABSTRACT FROM AUTHOR] |
