| Autor: |
KUCÍKOVÁ, LUCIE KEŘKOVÁ, ŠEJNOHA, MICHAL, JANDA, TOMÁŠ, PADEVĚT, PAVEL |
| Předmět: |
|
| Zdroj: |
Acta Polytechnica CTU Proceedings; 2023, Vol. 40, p54-60, 7p |
| Abstrakt: |
Glued laminated timber beams exposed to fire of a variable duration were tested in three point bending. Three types of model geometries taking into account the effect of burning were created. Each model was examined for five material data sets. The maximum deflection obtained from FEM simulations was compared with the corresponding deflection wel derived from a three point bending test of burnt beams. The analysis was performed with the help of Ansys® software limiting attention to a liner elasticity with the maximum applied force Fel selected at the proportionality limit observed experimentally. Majority of FEM models provided smaller deflections compared to measurements except for the material set adopting Young's moduli from the compression test. The best fit was observed for the material data set obtained from homogenization. No predominant preference among individual geometries was found promoting the computational model based on reduced cross-section as sufficiently accurate. [ABSTRACT FROM AUTHOR] |
| Databáze: |
Complementary Index |
| Externí odkaz: |
|
