| Autor: |
PANGJUNDEE, THONGCHAI, MUTTAMARA, APIWAT |
| Předmět: |
|
| Zdroj: |
MM Science Journal; Oct2021, p4791-4796, 6p |
| Abstrakt: |
Friction drilling is a process of using the friction between the rotating conical tool and the workpiece to generate heat and deform the work piece’s material and penetrate the hole. The softened material is pushed sideward and downward to make the bushing. This paper aimed to study the influence of friction drilling parameters. Thrust forces and torque forces were analysed. Experiments were carried out with a friction drill tool made of tungsten carbide on titanium grade Ti-6Al-4V. The parameters used in this study were spindle speed and feed rate. It was found that the thrust force and torque decreased with increased spindle speed and with decrease of feed parameters. The microstructure reveals that deformed grains at hole’s surface relate to hardness on the cross-section of workpiece. The highest value of microhardness was 813.2 HV and reduced to the original hardness of the matrix material. [ABSTRACT FROM AUTHOR] |
| Databáze: |
Complementary Index |
| Externí odkaz: |
|
